Fujitsu ETERNUS DX8100 S3 - FC Port

Chapter 5 Connectivity Status
5.3 CA Port Group
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
257
Filter setting
5.3.1 FC Port
Parameters of the FC ports that are registered in the ETERNUS DX/AF are displayed.
The following items are displayed in the Main area:
• Port
The location information (x: CE number, y: CM number, z: CA number, w: Port number) of the target port is
displayed.
- For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y CA#z Port#w
- For the other models
CM#y CA#z Port#w
• Type
The CA type of the target port is displayed.
• SFP Type
The SFP type of the target port is displayed. If an SFP is not installed, "Unmount" is displayed.
- SFP+(SMF)
An SFP (8G LongWave) that is installed in an 8Gbit/s (maximum) FC port.
- SFP+(MMF)
An SFP (8G SFP+) that is installed in an 8Gbit/s (maximum) FC port.
- 16G SFP+(SMF)
An SFP (16G LongWave) that is installed in a 16Gbit/s (maximum) FC port.
Filter Description
Name
Input the CA port group name that is to be displayed.
When not using the name for filtering, leave this item blank.
Type Select the type of the CA port group that is to be displayed.
CA Port Group Member
Select the location information of the member port for the CA port group that is to be
displayed.
Status Select the set state of the host affinity for the CA port group that is to be displayed.