Fujitsu ETERNUS DX8100 S3 - Page 266

Chapter 5 Connectivity Status
5.3 CA Port Group
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
266
• Status
The status of the target port is displayed.
• Port Mode
The mode (fixed at "CA") of the target port is displayed.
• Transfer Rate
The transfer speed (fixed at "10 Gbit/s") of the target port is displayed.
• FC Frame Size
The frame size of the target port is displayed.
"FC Frame Size" specifies the length of the communication information.
- 512 bytes
- 1024 bytes
- 2048 bytes
• VLAN ID
The VLAN ID of the target port is displayed.
• Fabric Name
The fabric name of the target port is displayed.
• Reset Scope
The reset scope of the target port is displayed.
Reset scope is the range where the command reset from the server is performed, when the target port is
connected to multiple servers.
- I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset request.
- T_L (T: Target, L: LUN)
Reset (cancels) the command request from all of the servers that are connected to the port.
• Release Reservation if Chip is Reset
Whether the function to release the reservation status of the volume when the target port (chip) is reset is
enabled or disabled is displayed.
• Host Group
The name of the host group that has the host affinity setting with the target port is displayed.
If no host group with the host affinity setting exists, a "-" (hyphen) is displayed.
• Port Group
The name of the port group to which the target port belongs is displayed.
If the target port does not belong to a port group, a "-" (hyphen) is displayed.
• WWN
WWNs of all FC/FCoE hosts that have the host affinity setting with the target port are displayed.
If the host affinity setting is not configured, the field is blank.