Fujitsu ETERNUS DX8100 S3 - Page 319

Chapter 6 RAID Group Status
6.5 RAID Group Detail (Basic)
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
319
• Total Capacity
The total capacity of the RAID groups is displayed.
• Total Free Space
The total free space in the RAID group is displayed.
• Controlling CM
The Controlling CM of the RAID group is displayed (x: CE number, y: CM number).
- For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y
- For the other models
CM#y
• Eco-mode Schedule
The Eco-mode schedule name that is assigned to the RAID group is displayed.
If the Eco-mode is controlled with Storage Foundation Software ETERNUS SF, "External" is displayed.
When no Eco-mode schedule has been assigned, the field is blank.
• Eco-mode Action
The Eco-mode schedule action status is displayed.
When no Eco-mode schedule has been assigned, a "-" (hyphen) is displayed.
- Drive power off
The power for the drive is turned off during Eco-mode operation.
- Drive motor off
The drive motor is stopped during Eco-mode operation.
- Drive always on
Disable Eco-mode and the drive is always active.
• Motor Status
The drive motor status is displayed.
- Active
The drive motors are activated.
- In the Boot Process
The drive motors are starting up.
- Idle
The drive motors are stopped.
- In the Stop Process
The drive motors are being stopped.
- Power Off
The drive power is being turned off.
• Fast Recovery Drive
When the hot spare area in the Fast Recovery RAID group is used (*1), the drive number for the data recov-
ery source drive is displayed. If Fast Recovery (*2) is not used, the field is blank.
This item is displayed only when the RAID level is "High Reliability (RAID6-FR)".
*1: The hot spare area is used from the beginning of high-speed rebuilding up until the copyback process (from the
hot spare area to the replaced normal drive) completes successfully.
*2: High-speed rebuilding when one drive fails in the Fast Recovery RAID group.
• CE Drive#yy (for the ETERNUS DX60 S3/DX100 S3/DX200 S3, the ETERNUS AF250, and the ETERNUS DX200F)
• DE#xx Drive#yy (xx: DE number, yy: Drive number)
• Process
A process that is being performed for the RAID group is displayed. If no process is being performed, a "-"
(hyphen) is displayed.