Fujitsu ETERNUS DX8100 S3 - Page 353

Chapter 7 Thin Provisioning Pool Status
7.2 Flexible Tier Pools
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
353
• Fast Recovery Configuration
The drive configuration in the Fast Recovery RAID group (*1) is displayed.
This item is displayed only when the RAID level is "High Reliability (RAID6-FR)".
- (4D+2P)x2+1HS
- (6D+2P)x2+1HS
- (8D+2P)x3+1HS
- (4D+2P)x5+1HS
D: Data drives, P: Parity drives, HS: Hot Spares
*1: "RAID6-FR" groups that configure FTSPs are called "Fast Recovery RAID groups".
• Total Capacity
The total capacity of the RAID groups is displayed.
• Used Capacity
The used capacity of the RAID groups is displayed.
"Used Capacity" indicates the total for the physically allocated capacities of the FTVs in the RAID group.
• Controlling CM
The Controlling CM of the RAID group is displayed (x: CE number, y: CM number).
- For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y
- For the other models
CM#y
• Eco-mode Schedule
The Eco-mode schedule name that is assigned to the RAID group is displayed.
If the Eco-mode is controlled with Storage Foundation Software ETERNUS SF, "External" is displayed.
When no Eco-mode schedule has been assigned, the field is blank.
• Eco-mode Action
The Eco-mode schedule action status is displayed.
When no Eco-mode schedule has been assigned, a "-" (hyphen) is displayed.
- Drive power off
The power for the drive is turned off during Eco-mode operation.
- Drive motor off
The drive motor is stopped during Eco-mode operation.
- Drive always on
Disable Eco-mode and the drive is always active.
• Motor Status
The drive motor status is displayed.
- Active
The drive motors are activated.
- In the Boot Process
The drive motors are starting up.
- Idle
The drive motors are stopped.
- In the Stop Process
The drive motors are being stopped.
- Power Off
The drive power is being turned off.