Chapter 2 System Status
2.1 System (Basic Information)
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
37
■ For the other models
The following items are displayed in the Main area:
● System Information
• Storage System Name
The name for the ETERNUS DX/AF is displayed.
By clicking this item, the [Storage] screen in the [Component] navigation is displayed.
• Model Name
The model name of the ETERNUS DX/AF is displayed.
• Unified Storage
The support status of the unified storage function is displayed.
If the Unified Storage function is enabled, the ETERNUS DX can be used as a Unified Storage system (a SAN
system and a NAS system).
For the ETERNUS DX60 S3 and the ETERNUS DX8100 S3/DX8700 S3/DX8900 S3, this item is not displayed.
For the ETERNUS AF250/AF650 and the ETERNUS DX200F, "Disable" is displayed.
• Deduplication/Compression
Whether the Deduplication/Compression function is enabled or disabled is displayed.
For the ETERNUS DX60 S3/DX100 S3 and the ETERNUS DX8100 S3/DX8700 S3/DX8900 S3, this item is not
displayed.
• Storage Cluster
If a license for the Storage Cluster function has already been registered, "Enable" is displayed. If the license
is not registered, "Disable" is displayed.
Note that ETERNUS Web GUI cannot be used to register a Storage Cluster license. To register the license, use
ETERNUS SF Storage Cruiser.
For the ETERNUS DX60 S3, this item is not displayed.
When upgrading a SAN system to a Unified Storage system, after the unified firmware is applied to the
active and inactive controllers, this item is changed to "Enable".
To Next Page
Loading...
