Fujitsu ETERNUS DX8100 S3 - Page 42

Chapter 2 System Status
2.2 Network
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
42
• Speed and Duplex
The transfer speed and the communication method are displayed.
- Auto-negotiation
- 1Gbit/s
- 100Mbit/s Half
- 100Mbit/s Full
- 10Mbit/s Half
- 10Mbit/s Full
• Master IP Address
The IP address of the Master CM, which has been specified to the port, is displayed.
If not specified, the field is blank.
• Slave IP Address
The IP address of the Slave CM, which has been specified to the port, is displayed.
This item is not displayed for the 1CM model.
If not specified, the field is blank.
• Subnet Mask
The Subnet Mask, which has been specified to the port, is displayed.
If not specified, the field is blank.
● SNMP Information
• SNMP Function
Whether the SNMP function is enabled or disabled is displayed.
● E-Mail Information
• Notification E-Mail
Whether the E-mail notification is enabled or disabled is displayed.
■ IPv6 Settings
The network setting information is displayed.
The SNMP Information and the E-Mail Information are displayed under the network setting information.