CHAPTER 3
Small Configuration
Installing the 19-Inch (FC9682HSW3) Heat Baffle
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
3-48
Fujitsu and Fujitsu Customer Use Only
This procedure provides instructions for installing the 19-inch (FC9682HSW3) heat baffle
(see Figure 3-30 [p. 3-47]) in a 19-inch or 23-inch relay rack.
The FC9682HSW3 heat baffle has a nominal width of 19 inches and can be installed in
either a 19-inch relay rack (see Figure 3-31 [p. 3-48]) or a 23-inch relay rack (see Figure 3-32
[p. 3-49]). In either case, two flanges are used. Table 3-4 [p. 3-48] lists the flange kit part
numbers.
Note: The 23-inch (FC9682HSW2) heat baffle can be used instead of the 19-inch (FC9682HSW3)
heat baffle in 23-inch rack applications. Refer to Section 3.9, Installing the 23-Inch
(FC9682HSW2) Heat Baffle [p. 3-45].
Table 3-4: Flange Kits for 19-Inch Heat Baffle Installation
Flange Kit Part Number
Flange kit for 19-inch relay rack installation FC9503FLG3
Flange kit for 23-inch relay rack installation FC9503FLG4
Figure 3-31: 19-Inch Heat Baffle Mounting in 19-Inch Relay Rack
Top View of 19-Inch Heat Baffle
Top View of 19-Inch Heat Baffle
Installed in 19-Inch Rack
19-Inch Rack
Left Shelf
Flange
Right Shelf
Flange
m1714ux_1
To Next Page
Loading...