CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Overview
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-2
Fujitsu and Fujitsu Customer Use Only
6.1 Overview
This chapter provides prerequisites and procedures for installing Plug-in Units, Filler Panels
and Modules used in the FLASHWAVE® 7500 Core, Small, ETSI, and Extension
Configuration systems.
6.2 Prerequisites
The following considerations apply when installing/removing Modules, Filler Panel and
Plug-in Unit procedures:
■
All rules and precautions are to be observed regarding electrostatic discharge (ESD).
■
Insure that all data forms and job engineering drawings have been completed and are
available.
To Next Page
Loading...
