CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing Shelf Plug-In Units
6-3
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
6.3 Installing/Removing Shelf Plug-In Units
This procedure includes the following subprocedures: Procedure
6.3.1 Removing Plug-In Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-4
6.3.2 Installing Plug-In Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-5
The procedures in this section are for removing and installing the plug-in units into a shelf
slot.
The following cautions must be adhered to when removing and installing all plug-in units:
Do not push plug-in units quickly into the slot. Seat all plug-in units (including the fans)
with a slow but firm motion to avoid damage to the plug-in unit or backplane connections.
Plug-in units can be damaged by an ESD during installation or removal. Read the general
notes (depending on the configuration) for plug-in unit storage, unpacking, and handling
in:
■
Core: Section 2.4, Storing, Unpacking, and Inspecting Equipment [p. 2-11]
■
Small: Section 3.4, Storing, Unpacking, and Inspecting Equipment [p. 3-20]
■
ETSI: Section 4.4, Storing, Unpacking, and Inspecting Equipment [p. 4-10]
■
Extension: Section 5.4, Storing, Unpacking, and Inspecting Equipment [p. 5-3]
Wear an ESD wrist strap with a minimum resistance of 1 megohm when handling plug-in
units to prevent possible plug-in unit damage. Before using the strap, check it for opens,
shorts, and the minimum resistance value. If the strap does not pass these checks, do not
use it.
To Next Page
Loading...