CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing Shelf Plug-In Units
6-5
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4 Grasp both upper and lower plug-in unit levers with thumbs and forefingers, and slowly pull
the plug-in unit out of the shelf.
5 Place the plug-in unit in ESD protective packaging.
This procedure is complete.
6.3.2 Installing Plug-In Unit
1 Locate the replacement plug-in unit or the plug-in unit to be installed.
2 Remove the plug-in unit from its ESD protective packaging.
3 Ensure that the top and bottom extractor levers are open. See Figure 6-2 [p. 6-5].
Figure 6-2: Plug-In Unit Installation Sequence
To Next Page
Loading...