CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing Shelf Plug-In Units
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
6-4
Fujitsu and Fujitsu Customer Use Only
6.3.1 Removing Plug-In Unit
1 Locate the shelf plug-in unit that is to be replaced. See Figure 6-8 [p. 6-14].
2 Label and remove all fibers connected to the unit being replaced.
3 Gently pull open the top and bottom extractor levers until the plug-in unit is free from the
rear connector. See Figure 6-1 [p. 6-4].
Figure 6-1: Plug-In Unit Removal Sequence
To Next Page
Loading...