Fujitsu Primergy RX300 S4 - Page 172

172
Chapter 6 Installing Internal Options
7 Remove the USB unit.
1. Push the ejector in the direction of the arrow (on the front) while holding up the USB
unit lock (green) inside of the server to unlock it.
2. Remove the USB unit from the server.
8 Remove the cables inside of the server and open the holder of the 3.5-inch
storage bay while pressing the tabs.
The holders are on both sides of the server. Open both of them in the same way.
USB
unit lock
Ejector
(1)
(2)
USB unit
[Front]
Tab s
Holde
r
Power connector
SAS connector
USB connector