FUTABA 7XC - Page 130

Alarm time
OFF, 1~99 minutes
Initial value: 5 minutes
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Pre-alarm time
OFF, ON
Initial value: OFF
- Tap (ON) / (OFF).
Grip vibrator type (pattern)
Inhibit(Off), Type 1,2,3
Initial value: Inhibit
- Tap (ON) / (OFF).
If you start without resetting
the last lap timer, it will be dis-
played.
Start / Stop
Status display
Timer reset
130
Function
Timer
(Preparation)
Select the "Lap timer" from the timer type list and tap.
1
(Alarm time setting)
Tap the value button of the "Alarm time".
Value input buttons appear on the screen.
Use the [+] and [-] buttons to set the time
amount.
Tap [Vibrate] and select the vibration pat-
tern of the alarm from 3 types of patterns
and disable (OFF).
(Pre-alarm setting)
Tap (ON) or (OFF) of pre-alarm and select ON / OFF.
2
(Timer start operation)
Perform the start and lap count operations with the switch
("Timer start") assigned by function select
switch function.
- Linking only start to the throttle stick
Tap [OFF] of the throttle stick to display
[Ready] and wait for the throttle stick op-
eration. When you operate the throttle stick
to the forward side, the timer starts. Stop is
the same as when starting with a switch.
* You cannot start it unless you reset the last lap tim-
er. If the lap timer is reset, the lap list (page 132) is
also cleared.
3
(Timer stop and lap reset operation)
When the lap count switch or ("Timer re-
set") switch is pressed after the time set by
"Alarm" has elapsed and the lap time, total
time, and average lap time are saved and
checked. (Lap list page 132) If the switch
("Timer reset") set by switch setting func-
tion is pressed, the timer is reset.
When a switch is not set, tap [Reset] on the
screen. The timer is reset with the beeping
sound.
Using the lap timer