Alarm time
OFF, 1~99 minutes
Initial value: 5 minutes
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Pre-alarm time
OFF, ON
Initial value: OFF
- Tap (ON) / (OFF).
Grip vibrator type (pattern)
Inhibit(Off), Type 1,2,3
Initial value: Inhibit
- Tap (ON) / (OFF).
Lap navi time
OFF, 1~99 seconds
Initial value: 3 seconds
Start / Stop
Status display
131
Function
Timer
(Preparation)
Select the "Lap navigate timer" from the timer type list and tap.
1
(Alarm time setting)
Tap the value button of the "Alarm time".
Value input buttons appear on the screen.
Use the [+] and [-] buttons to set the time
amount.
Tap [Vibrate] and select the vibration pat-
tern of the alarm from 3 types of patterns
and disable (OFF).
(Pre-alarm setting)
Tap (ON) or (OFF) of pre-alarm and select
ON / OFF.
(Lap navigation time setting)
Tap the value button of the "Lap navi". Value input buttons
appear on the screen. Use the [+] and [-] buttons to set the
time amount.
2
(Timer start / navigation restart operation)
When the switch (Timer start) assigned by switch select
function is pressed, the timer starts.
When you press the switch (Timer start) or [Start] / [Reset]
on the screen during timer operation, the timer stops.
- Linking only start to the throttle stick
Tap [OFF] of the throttle stick to display
[Ready] and wait for the throttle stick op-
eration. When you operate the throttle stick
to the forward side, the timer starts. Stop is
the same as when starting with a switch.
When your own lap time is less than the
target time and the lap counts overlap, the
lap navigation alarm timing is too big. The
alarm timing can be corrected by pressing
the switch ("Timer start") during measurement.
Using the lap navigate timer
To Next Page
Loading...
