FUTABA 7XC - Page 135

135
Function
S.BUS Servo
2
(S.BUS/S.BUS2 servo read)
Tap the
[
Read] button. The notes on wireless setting
are displayed. Tap the [Close] button.
Once this screen is displayed, it will not be displayed
again until you turn the power back on.
Touch the channel in which the servo to be set is con-
nected and read the setting data from the servo.
- Communication port: T7PX communication port (conventional wired setting).
- Wireless 1 (Rx Ch1): Receiver channel 1
- Wireless 2 (Rx Ch2): Receiver channel 2
-"Reading succeeded" is displayed on the screen and the ser-
vo’s ID cord and currently set contents are read.
- If "Failed" is displayed on the screen, communication with
the servo is not being performed normally.
Check the T7XC and servo connection to servo and repeat
[Read]. (Connect the battery to a non-high voltage (HV) sup-
port servo.)
3
(Writing to S.BUS/S.BUS2)
Execute this function to write the setting data to
servo. See pages 137 to 138 for the setting data
contents. Tap the [Write]. The confirmation screen
will be displayed. To execute, tap [Yes] to hear an
electronic sound and finish setting. To cancel, se-
lect [No] and tap it.
-"Writing succeeded" is displayed on the screen and the setting
data is written to servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed normally. Check the T7XC and servo connection to servo and repeat [Write]. (Connect
the battery to a non-high voltage (HV) support servo.)
4
(Initialization)
Write the factory set servo setting data to the con-
nected servo. Tap the [Reset]. The confirmation
screen will be displayed. To execute, tap [Yes] to
hear an electronic sound and finish setting. To can-
cel, select [No] and tap it.
-"Writing succeeded" is displayed on the screen and the setting
data is written to servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed normally. Check the T7XC and
servo connection to servo and repeat "Write". (Connect the
battery to a non-high voltage (HV) support servo.)