158
Chapter 8: Managing Power
www.gateway.com
Installing a secondary battery
Your notebook’s modular bay accepts a secondary battery. The secondary
battery charges when the notebook is connected to AC power.
To install a secondary battery:
1 If you are removing a disc drive, diskette drive, or a memory card reader,
make sure that the module is empty.
2 Make sure that your notebook is off (not in Standby or Hibernate mode).
3 Close the LCD panel.
4 Disconnect your notebook from the optional port replicator (see
“Disconnecting from the port replicator” on page 249).
5 Turn your notebook over so the bottom is facing up.
Warning Danger of explosion if battery is incorrectly replaced.
Replace only with a Gateway 450ROG or
Gateway 450RGH secondary battery. Discard used
batteries according to the manufacturer’s instructions.
The battery used in this device may present a fire or
chemical burn hazard if mishandled. Do not disassemble,
heat above 212°F (100°C), or incinerate. Dispose of used
battery promptly. Keep away from children.
To Next Page
Loading...
