1. INTRODUCTION
1.2 Safety Instructions
General Safety Instructions
• The SR-1000 is intended for installation in a DCI-compliant Digital Cinema Projector.
• The operational temperature required should be within 0ºC - 40ºC (32ºF - 104ºF).
250 LFM airflow must always be present over the IMB from right to left (looking from
the front of the IMB) when powered ON.
• The operating humidity should be within 20% to 90%, non-condensing.
• Before operating the SR-1000, please read this manual thoroughly, and retain
it for future reference.
• Installation and preliminary adjustments should be performed by qualified
GDC Technology personnel.
• All warnings on the SR-1000 mentioned in this documentation manual should
be adhered to.
•
All instructions for operating and maintaining the
SR-1000
must be followed closely.
Electrical Safety
Safety
Warning
• Do not expose the SR-1000 to rain or moisture, to prevent fire or electrical shock hazard.
• Consult GDC Technical Support for servicing or maintaining the SR-1000.
• You are cautioned that any change or modification not expressly approved in this manual
or approved in writing by an authorized representative of GDC Technology could void your
warranty and/or authority to operate the SR-1000.
Testing and Certification
• The SR-1000 has passed multiple Quality Assurance and Quality Control certifications,
issued by SGS Labs - the world’s leading inspection, verification, testing and
certification company.
• Refer to Section 11 for detailed test reports.
To Next Page
Loading...
