ActionStep
In the Process Picture:7
•
Click on the Pumps.
•
Set the System flow to an appropriate value for the Superloop size, in this example
10 ml/min.
•
Click Set flow rate.
Result: A system flow starts, in this example of 10 ml/min.
When the Superloop is filled with as much volume as is needed, click the End icon in the
System Control toolbar to end the run.
8
Plug the Syr port on the Injection valve with a Stop plug.9
ÄKTA pure User Manual 29119969 AB 189
5 Operation
5.7 Sample application
5.7.2 Sample application using a Superloop
™
To Next Page
Loading...
