GE AKTApure - Page 202

Assembly instructions
Follow the instructions below to assemble the Tube rack.
ActionStep
Insert the Tube support (4), if required, into the bowl (3). The circular marks on the Tube
support should face down.
1
1
2
3
4
5
6
Note:
When assembling a Tube rack, Single cutouts (1) and L-shaped cutouts (2), are used for
various inserts depending on the length of the collection tubes. See Single and L-shaped
cutouts, on page 201 for detailed information.
Insert the Tube guide (5) with the tube position numbers upwards. The Tube guide should
rest about 1 cm above the Tube support.
2
Insert the Tube holder (6) with the tube position numbers upwards:3
Check that tube position 1 (7) is directly above tube position 1 (7) of the Tube guide.
7
202 ÄKTA pure User Manual 29119969 AB
5 Operation
5.8 Fractionation
5.8.2 Prepare Fraction collector F9-R