•
Versatile valve
•
I/O-box
•
UV monitor, 2nd
It is possible to reset the UV monitor U9-L, 2nd using Phase Properties. All other UV monitor
U9-L, 2nd instructions need to be edited in the Text Instruction mode.
Note:
If installing more than one external air sensor, it is necessary to create the methods for the
additional air sensors using the Text Instruction mode.
Note:
Open and save methods for different systems
New ÄKTA pure methods are always created for the set of components of the current system. Methods
can be shared between systems, with the restriction that a method created for an ÄKTA pure 150
configured system cannot be used with an ÄKTA pure 25 configured system, and vice versa.
When a method is opened for a system that has been changed or if a method is saved for a system
with a different flow configuration, a dialog is opened where the user can choose to either adapt the
method or to keep the text method unchanged.
ÄKTA pure User Manual 29119969 AB 215
5 Operation
5.9 Create a method and perform a run
5.9.1 Create a method
To Next Page
Loading...
