ActionStep
Remove the tubing connector from the dispenser head:3
•
Open the fraction collector and gently move the fractionation arm forward.
•
Unscrew the connector from the dispenser head and remove the tubing.
•
Gently move the fractionation arm all the way back.
Cut the new tubing to the same length as the old tubing. Use a tubing cutter to get a
straight angle cut.
4
CAUTION
Cut injuries. The tubing cutter is very sharp and must be handled with
care to avoid injuries.
Note:
Use tubing with the original inner diameter and length to ensure that the correct delay
volume is maintained.
320 ÄKTA pure User Manual 29119969 AB
7 Maintenance
7.8 Replacement procedures
7.8.2 Replace internal tubing in Fraction collector F9-C
To Next Page
Loading...
