GE AKTApure - Page 490

DescriptionRange/UnitRun Data
The temperature signal (in the conductivity
flow cell).
0.0 – 99.0 °CCond temp
The pH signal.0.00 – 14.00pH
The set position of the pH valve.N/ApH valve
The set position of the outlet valve.N/AOutlet
The current tube position of the fraction col-
lector.
N/AFrac position
The current tube position of the fraction col-
lector 2.
N/AFrac 2 position
The set position of the X1 valve.N/AInlet valve X1
The set position of the X2 valve.N/AInlet valve X2
The set position of the versatile valve.N/AVersatile valve
The set position of the versatile valve 2.N/AVersatile valve 2
The set position of the versatile valve 3.N/AVersatile valve 3
The set position of the versatile valve 4.N/AVersatile valve 4
The current state of the air alarm for the inte-
grated air sensor in inlet valve A.
No air, AirAir inlet A
The current state of the air alarm for the inte-
grated air sensor in inlet valve B.
No air, AirAir inlet B
The current state of the air alarm for the inte-
grated air sensor in inlet valve IS.
No air, AirAir inlet S
The current state of the air alarm for the ex-
ternal air sensors.
No air, AirExt. air sensor, to
Ext. air sensor 4
The I/O-box analog input signals.-2000.0 – 2000.0 mVAnalog in 1, to
Analog in 4
The I/O-box digital input signals.0, 1Digital in 1, to
Digital in 8
The set value of the I/O-box digital output
signals.
0, 1Digital out 1, to
Digital out 8
490 ÄKTA pure User Manual 29119969 AB
9 Reference information
9.10 Available Run data