D20/D200
Installation and Operations Guide
GE Energy
994-0078-2.00-7 General
114
Full
D20/D200 Software Configuration, continued
About Multi-
Node
Downloads
D20ME II VME modules can be used in a multi-node VME system, known as a
D200. The application code for each D20ME II module in a multi-node system can be
the same or different for one or more of the modules.
The download procedure is the same for a multi-node system as for a single node;
repeat the procedure for each node.
Note:
Do not restart (i.e. Boot) the multi-node system until you have finished
downloading code to all the D20ME II cards.
D20EME
Global Memory
Expansion
If you have installed the D20EME for global memory expansion of your D20/D200
system, you must configure the parameters for this in Config Pro:
• Memory starting address
• Size of Global Memory
Consult the On Line Help in Config Pro for how to do this.
D20EME
Ethernet
Interface
If you have installed the D20EME for Ethernet interface capability on your
D20/D200 system, you must enable the LAN interface and configure the parameters
for this in Config Pro:
• IP and Ethernet addressing
• BootP settings
• Single or dual LAN selection
Consult the On Line Help in Config Pro for how to do this.
To Next Page
Loading...
