GE Energy
D20/D200
Installation and Operations Guide
General 994-0078-2.00-7
Full
69
Connections and Configuration, continued
WESTERM
D20K: Jumpers
Jumper locations on the WESTERM D20K:
To set Module address jumpering on Z1, see “WESTERM Addressing”, page 65.
Use ju
mpers:
• Z2 and Z3 for supply voltage setting
• Z4 to Z39 to set Trip/Close, Raise/Lower and Control Outputs
See table below, next page.
Z1
Z2 & Z3
Z4 to Z39
To Next Page
Loading...
