GE Energy
D20/D200
Installation and Operations Guide
General 994-0078-2.00-7
Full
71
Connections and Configuration, continued
WESTERM
D20C: Jumpers
Jumper locations on the WESTERM D20C:
To set Module address jumpering on Z1, see “WESTERM Addressing”, page 65.
Use ju
mpers:
• Z2 and Z3 for supply voltage setting
• Z19 and Z20 for contact wetting configuration
• Others to set Trip/Close, Raise/Lower and Control Outputs
See table below, next page.
Z1
Z2, Z3 & Z4
JPs Z17 & Z18
Z9 to Z16
Z19 & Z20
Z17 & Z18
To Next Page
Loading...
