GE Druck DPI 620 Genii - Page 52

User Manual Druck DPI620 Genii
Example A Example B
Measure frequency on
CH1
Range: 0 to 50 kHz
Trigger level: 2.5V
Source frequency on CH1
Range: 0 to 50 kHz
Waveform: Square
Amplitude:5.0 V
1. Set the applicable
software options
2. Complete the electrical
connections
3. If necessary, change the
Trigger Setup
SETTINGS >>
AUTO TRIGGER
4. Set the values that
follow:
AUTO TRIGGER
(Enabled / Disabled)
MANUAL LEVEL
Trigger Level for
Manual Trigger only
1. Set the applicable software
options
2. Complete the electrical
connections
3. If necessary, change the
Waveform Setup:
SETTINGS
4. Set the values that follow:
WAVEFORM
Square
Triangle
Sine
AMPLITUDE
Peak to Peak Amplitude
OFFSET
Only Applies to Sine and
Triangle
06 June 2013 K0541 issue 1 Page 52 of 175