GE LOGIQ E10

DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
6 - 10 Section 6-3 - Monitor Arm and/or Monitor range of motion Adjustment procedure
Section 6-3
Monitor Arm and/or Monitor range of motion Adjustment procedure
Contents in this section
6-3-1 Purpose of this section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-10
6-3-2 Cautions and Warnings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-10
6-3-3 Main Monitor Arm and Monitor Friction Adjustment - Ergotron Arm . . . . . . . . . . . . . . . .6-11
6-3-1 Purpose of this section
This section describes how to adjust the Monitor Arm and/or Monitor range of motion for optimal
performance.
6-3-2 Cautions and Warnings
Table 6-3 LOGIQ E10 Monitor Arm
Ergotron Arm
Adjustments available
Monitor Range of motion and
Monitor Arm vertical adjustment.
Table 6-4 Be aware of pinch points at hinges when adjusting Monitor Arm and Monitor