112 GE INFORMATION D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
CHAPTER 10: MAINTAINING A D20E MODULE FIRMWARE
If it is necessary to update the D20E module firmware:
1. Power up the D20E module.
2. Connect the D20E module to the DAPserver Studio (running on a Windows PC) via the
LAN port.
3. Select Update from the Device menu tab.
Result: The Device Information window appears.
4. Type in the IP Address of the D20E module.
5. Type in the Username and Password login credentials (default: admin).
6. Click OK.
Result: The Update window appears.
7. Select the update to include:
– Application update
– Application - update OS. It is necessary to update the OS as well for a D20E
Ethernet I/O Module.
8. Click OK.
Result: The Updating … window appears, showing the progress of the firmware
download.
Result: The D20E module automatically restarts after a successful download, in order
for the new firmware to take effect.
9. When the D20E module restart is complete, reconnect to the D20E module:
9.1. Open the Device menu bar.
9.2. Click Explore.
Result: Explorer opens.
10. Check that the firmware version and point status are all in a good state.
You cannot downgrade to an older firmware version.
IP address: 192.168.0.xxx
Ethernet crossover cable
IP address: 192.168.0.xxx
Windows PC
D20E Ethernet I/O module
To Next Page
Loading...