36 GE INFORMATION D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
CHAPTER 2: INSTALLING THE D20E MODULE
Installation process
The tasks required to install a D20E module in a system are:
1. Configure the firmware; see chapter: Configuring the D20E Firmware on page 37.
2. Mount the D20E module in a 19" rack or cabinet; see chapter: Mounting a D20E
Module on page 75.
3. Connect to devices and networks; see chapter: Connecting to Devices and Networks
on page 77.
4. Power-up the D20E module and run the preliminary power up and test; see chapter:
Preliminary Power Up and Test on page 83.
5. Connect the field wiring; see sections:
– D20E-A analog inputs module on page 87
– D20E-K control outputs module on page 89
– D20E-S digital inputs module on page 95
– D20E-C combination inputs and outputs module on page 97
6. Power-up the D20E module and verify that D20E module is functioning properly; see
chapter: Powering-up and Testing a D20E Module on page 101.
7. Monitor D20E module operation; see chapter Using the D20E Module on page 103
To Next Page
Loading...
Need help?
General
