34 GE INFORMATION D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
CHAPTER 1: BEFORE YOU START
O Indicates that this toxic or hazardous substance contained in all of the
homogeneous materials for this item is below the limit required in GB/T 26572
and EU Directive 2011/95/EU (RoHS 2)
X: Indicates that this toxic or hazardous substance contained in at least one of the
homogeneous materials used for this item is above the limit requirement in GB/T
26572 and EU Directive 2011/95/EU (RoHS 2)
The maximum concentration limits (MCV's) apply.
Lead (Pb) 0.1% by weight = 1000 mg/kg = 1000 ppm
Mercury (Hg) 0.1% by weight = 1000 mg/kg = 1000 ppm
Cadmium (Cd) 0.01% by weight = 100 mg/kg = 100 ppm
Chromium VI (Cr6) 0.1% by weight = 1000 mg/kg = 1000 ppm
PBB, PBDE 0.1% by weight = 1000 mg/kg = 1000 ppm
China RoHS 2
Statement
The D20E products are specifically designed for, and used as a products related to power
generation, transmission and distribution equipment of electric energy. According to
Article 3 (1) of “The Methods”, power generation, transmission and distribution equipment
of electric energy is excluded. The D20E products are therefore excluded from this scope.
Storage recommendations
Storage conditions
Always store the D20E in an environment compatible with operating conditions.
Recommended environmental conditions for storage are:
•Temperature: ‒40 °C to +85 °C
• Relative humidity: 5% to 95%, non-condensing
• Maximum altitude: 12192 m [40,000 feet] above sea level
To avoid deterioration and early failure of electrolytic capacitors, power up units that are
stored in a de-energized state once every 12 months, for one hour continuously.
To Next Page
Loading...
Need help?
General
