GE COMPANY
DIRECTION 5472001-1EN, REVISION 6OPTIMA CT680 SERIES AND OPTIMA CT670 INSTALLATION MANUAL
Chapter 4 - System Covers: Installation & Alignment Page 155
4 - Continuity Checks
Section 4.0 Table Covers Installation (Lite Table)
4.1 Table Base Cover
Figure 4-17 Table Base Cover
4.2 Flapper Installation
1.) Insert two (2) plastic rings into the left side of flapper and the right side of flapper.
2.) Attach two flapper brackets to the flapper.
3.) Tighten it to the Table rear bottom by four (4) support bracket screws. There is a gap between
the flapper and the table arm as shown in the Illustration below. When the flapper is installed
on the table base, the left gap and the right gap must be equal using four (4) support bracket
screws.
To Next Page
Loading...
