GE COMPANY
DIRECTION 5472001-1EN, REVISION 6OPTIMA CT680 SERIES AND OPTIMA CT670 INSTALLATION MANUAL
Chapter 1 - Position Subsystems Page 27
1 – Pos. Subsystems
2.3 Required Common Tools and Supplies
The following tools and supplies should be included in the standard CT installation tool kit. The tools
listed represent the minimum tools required for installing this CT scanner.
Wrenches
• Standard and metric combination wrench sets
• Standard and metric hex key (Allen wrench) sets
• ½ in. and 3/8 in. (9.5mm), drive torque wrench: 0-100 N-m (0-100 ft.-lb.) Must be calibrated
yearly.
Sockets and Extensions
• 3/8 in. drive metric and standard socket set
• 1 in, 1-1/8 in, 1-¼ in, 1-½ in, 1-5/8 in sockets
• ½ in. drive ratchet wrenches
• ¾ in. deep well socket
• Metric hex bit set ¼ in. or 3/8 in. drive, including 10 mm and 14 mm hex bit
• 3/8 in. drive universal joint
• 21mm socket (optional)
Screw Drivers
• Torque Screwdriver
• Phillips screwdriver set (small, medium, and large)
• Straight blade screwdriver set (small, medium, and large)
• Pozi-drive 0 (S)
• Pozi-drive #1
• Hex bit set with: Flat blade bit, Plus blade bit, Hex bits, and Star bits.
Drill Bits
• Complete set of standard (U.S.) drill bits
• Metric tap set (Optional)
• ½ in. masonry bit, min. 10 in. long USA; 12 in. optional (Bit must not be metric.)
• 4" (100mm) hole saw with 1/8" (5mm) masonry bit (to remove flooring)
Power Tools
• 3/8 in. or ½ in. drill, cordless or electric
• Reciprocating saw (Sawzall or equivalent) and assorted blades
• Hammer Drill & BIt (8 in. min, 12 in. max)
• Sears shop vacuum or equivalent, with HEPA or drywall dust filter
• 25 ft. extension power cords