GE COMPANY
DIRECTION 5472001-1EN, REVISION 6OPTIMA CT680 SERIES AND OPTIMA CT670 INSTALLATION MANUAL
Chapter 1 - Position Subsystems Page 65
1 – Pos. Subsystems
To adjust two leveling pads at rear end of table, please insert the screw driver into the hole located
on the bolt then rotate the bolt, refer to the Figure 1-41.
Figure 1-41 Adjust Leveling Pads
10.3.2 Cradle Center Procedure
1.) Remove a bottom cover under a cradle handle. See Figure 1-42.
Figure 1-42 Remove Bottom Cover
To Next Page
Loading...
