GE PACSystems RX7i

Chapter 9. Diagnostics
GFK-2950C February 2018 427
Category
Fault Type
Fault Description
Fault Extra Data
IOC Software Fault (11)
NA
NA
NA
Forced Circuit (12)
NA
NA
Block Configuration
Discrete/Analog
Indication*
Unforced Circuit (13)
NA
NA
Block Configuration
Discrete/Analog
Indication*
Loss of I/O Module (14)
NA
NA
NA
Addition of I/O Module
(15)
NA
VME Module Reset
Requested (30 hex)
NA
Extra I/O Module (16)
NA
NA
NA
Extra Block (17)
NA
NA
NA
IOC Hardware Failure
(18)
NA
NA
NA
GBC stopped reporting
faults because too
many faults have
occurred (19)
GBC detected high error
count on Genius Bus and
dropped off the bus for at
least 1.5 seconds. (1)
NA
NA
GBC Software
Exception (21)
Datagram queue full (1)
R/W request queue full (2)
Low priority mail rejected
(3)
Background message
received before CPU
completed initialization (4)
Genius software version
too old (5)
Excessive use of internal
GBC memory (6)
NA
Block Switch (22) –
redundant Genius
block switched bus
NA
NA
Block Configuration
Number of Input Circuits
Number of Output
Circuits
Rack/Slot address of
GBC from which block
was removed.
Block not active on
redundant bus (23)
NA
NA
NA
Reset of IOC (27)
NA
NA
NA
PROFINET network
faults (33 and higher)
NA
Refer to PROFINET controller
documentation.
NA