80209C_MHW_850-1650-1850_02-2020_ENG_pag. 72
4.7. Submenu PR.OPT - Configuring programs
Acronimo
Messaggio
a scorrimento
Password
d’accesso
Descrizione
PR.OPT PROGRAMMER
CONFIGURATION
Livello 1
Lets you configure the 16 programs manageable by the programmer.
The parameters are configured for each program to be used.
The Programmer function must previously be enabled with the
MODE.1 and/or MODE.2 menus, assigned, respectively, with
PID.1 and PID.2, with parameter PROGR = On.
If “Simplified Programmer” mode is active (S.PROG parame-
ter set to EN.FUN )), the controller can manage 12 programs,
each of which has up to 16 configurable steps.
For more information on configuring the programmer, see
paragraph “5.13. Setpoint programmer” on page <?>.
PR.OP.N
FI.STP
LA.STP
Strt
RST.SP
WAIT.S
End
LIMIT
MSG.EN
Selecting program 73
Number of first step
assigned to program
73
Number of last step
assigned to program
73
Restart mode 22
Type of control after
program restart
73
Option to start
execution of program
23
Action at end
of program
74
Message associated at
the end of the program
74
Messaggio associato
alla fine del
programma
74
Parameter Pag.
To Next Page
Loading...
Need help?
General
