80209C_MHW_850-1650-1850_02-2020_ENG_pag. 96
4.9.20. MSG.SB - Selecting the message assigned to Sbr
Acronym Scrolling message Submenu Attributes
MSG.SB INPUT.1 (or INPUT.2 or INPUT.3) NUM SCROLLING MSG WHEN INPUT IS SB
ERR
INPUT R W
The parameter shows and sets the number of the message assigned to Err (sensor break in short circuit or input values
above maximum limit), i.e., the scrolling message shown on the display.
For more information on scrolling messages, see paragraph “3.1.2.2. Scrolling messages” on page <?>.
If the parameter is set to “0” no message will be displayed for Sbr.
As default, MSG.SB is assigned the message “4” (for LANG1 corresponds to ““SENSOR BROKEN” 1 (or SENSOR 2 or
SONDA 3) , for LANG2 corresponds to “SONDA 1 (or SONDA 2 or SONDA 3) APERTA”.
Unit of measurement: Number message
Options: 0...25 (con LAnG=LANG1 oppure LANG2 oppure LANG3)
0…75 (con LAnG=NONE)
To Next Page
Loading...
Need help?
General
