EasyManuals Logo

gefran 1650 User Manual

gefran 1650
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
80209C_MHW_850-1650-1850_02-2020_ENG_pag. 82
4.8.26. EVN.H.2 - Event 2 during step hold
Acronym Scrolling message Submenu Attributes
EVN.H.2 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP HOLD se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP HOLD se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 2 during the step hold.
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive
4.8.27. EVN.H.3 - Event 3 during step hold
Acronym Scrolling message Submenu Attributes
EVN.H.3 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP HOLD se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP HOLD se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 3 during the step hold.
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive
4.8.28. EVN.H.4 - Event 4 during step hold
Acronym Scrolling message Submenu Attributes
EVN.H.4 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP HOLD se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP HOLD se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 4 during the step hold.
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive
4.8.29. GROP.R - Group of parameters assigned to ramp
Acronym Scrolling message Submenu Attributes
GROP.R PR.STP.1 (o PR.STP.2…PR.STP.192) CONTROL PARAMETER GROUP DU-
RING STEP RAMP se modalità“Programmatore semplificato”disattiva; o
PR.STP.1…PR.STP.16 CONTROL PARAMETER GROUP DURING STEP RAMP
se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the group of control parameters assigned to the step during the ramp.
Unit of measurement: Number
Options: 0...4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the gefran 1650 and is the answer not in the manual?

gefran 1650 Specifications

General IconGeneral
Brandgefran
Model1650
CategoryTemperature Controller
LanguageEnglish

Related product manuals