80209C_MHW_850-1650-1850_02-2020_ENG_pag. 92
4.9.8. FILT.D - Digital filter on PV display
Acronym Scrolling message Submenu Attributes
FILT.D INPUT.1 (or INPUT.2 or INPUT.3) DIGITAL FILTER ON DISPLAY PV INPUT R W
The parameter shows and sets the allowed tolerance between the real PV value and the value on the PV display: if the
variation in real PV is within the interval displayed value - FILT.D... displayed value + FILT.D the displayed value does not
change. With 0.00 no filter is applied..
Unit of measurement: The one set with the Unit parameter
Options: 0.0...9.9
4.9.9. DEC.P - Number of decimals displayed
Acronym Scrolling message Submenu Attributes
DEC.P INPUT.1 (or INPUT.2 or INPUT.3) DECIMAL POINT POSITION INPUT R W
The parameter shows and sets the decimal point position for the process value (PV) displayed, i.e., defines its number of
decimal figures.
The number of decimal set may reduce the limits of the measurement scale used.
Unit of measurement: Number
Options: 0...3 = Number of decimals displayed
0 / 1 = Number of decimals displayed, only for TC and RTD sensors
To Next Page
Loading...
Need help?
General
