EasyManuals Logo

Gema MagicControl 4.0 User Manual

Gema MagicControl 4.0
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
Rev. 01 12/21
104
After filter pressure monitoring MagicControl 4.0 (CM40)
Important information:
If the calibration was successful, the Fan Δp is now in a dynamic state.
(Operating point, alarm, ATEX: Stop powder)
The fan Δp values change by 10 steps for each speed increase of 1
Hertz. The entire display area Fan Δp adapts to the new operating point
value.
Exhaust air measurement
For exhaust air measurement we recommend the Testo 405i hot wire
anemometer, which is both economical and practical.
25 steps

Table of Contents

Other manuals for Gema MagicControl 4.0

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gema MagicControl 4.0 and is the answer not in the manual?

Gema MagicControl 4.0 Specifications

General IconGeneral
BrandGema
ModelMagicControl 4.0
CategoryControl Unit
LanguageEnglish

Related product manuals