Gema MagicControl 4.0 - CAN Bus; General

Rev. 01 12/21
32
•
Start-up MagicControl 4.0 (CM40)
CAN bus
General
The plant control is a CAN master system. Together with CAN slave
participants, it forms the network.
The wiring and topology of the CAN network is specified in the electrical
diagram.
The following data can be accessed via the CAN network:
– All desired values (process data)
– All actual values (process data)
– All control values
– All system parameters (except Baud rate and CAN address)
– All error messages
– All other parameters such as software version, daily correction,
powder output correction etc.