Gema MagicControl 4.0 - Search Coating Programs

Rev. 01 12/21
50
•
Operation MagicControl 4.0 (CM40)
another line only moves the selection.
2. Touch the highlighted line again.
– A keyboard opens to name the coating program.
Fig.
38
: Naming coating programs
3. Enter object name
4. Press the RET key to confirm
Search coating programs
Search by name
1. Press the search field (7)
– A keyboard opens to search for coating programs by
alphanumeric entry.
fig.
39
:
– Only coating programs that match the search are listed.
Pay attention to upper and lower case as well as spaces!