Gema MagicControl 4.0 - Naming Coating Programs

Rev. 01 12/21
MagicControl 4.0 (CM40) Operation
•
49
Fig.
35
:
2. Press the key
– Data is copied to the clipboard
3. Select the coating program to which the data shall be copied from
the clipboard
Fig.
36
:
4. Press the key
5. The following security prompt is displayed:
Would you like to overwrite the program?
6. Confirm
– Data is copied to the current coating program
Fig.
37
:
7. Naming a coating program
Naming coating programs
1. Touch the desired table entry.
– The line is highlighted.
Only lines which are highlighted can be changed, clicking on