Gema MagicControl 4.0 - Page 35

Rev. 01 12/21
MagicControl 4.0 (CM40) Operation
•
35
Fig.
19
:
7. Press the key.
– The following screen is displayed:
Fig.
20
:
The following functions are available:
– Modify and manage coating programs and application data
– Operating data management (LM)*
– Configuration and parameters*
– Diagnostics*
– Settings
* with the exception of some functions that are only available when the
after filter is running and the control units are switched on.
8. Turn the key switch to turn on the control voltage.
– The indicator lamp lights up.