- 119 -
10.3.2.3 Installation
Install bolt and ignition coil.
Install fuel tube, vacuum tube and bolt.
Install spark plug cap.
Connect carburetor fuel tube and vacuum tube.
Connect motor kinetic force hanger support to motor
assembly.
Install temporarily bolt and nut of motor kinetic force hanger
support.
10.4 Installation of motor
Install according to reversed procedures of "removal".
Note:
Detailed removal diagram is available in P102.
Torsion value of installation:
Motor standing axle 55-62 N·m
rear shock absorber standing bolt(upper): 37-44 N·m
rear shock absorber standing bolt(lower): 22-29 N·m
To Next Page
Loading...
