- 159 -
Remove clutch main shaft and output shaft gear.
Remove middle shaft and middle gear.
16.3.2 Output gear box cover inspection
Check abrasion and damage condition of clutch main shaft,
gear and bearing.
Change gear room cover bearing.
Press clutch main shaft in changing clutch main shaft bearing,
remove it from gear room.
Note:
Bearing knocked out shall not be used any more, and should
be replaced by new one.
Use special tools to disassemble bearing and oil seal.
Remove oil seal of gear box and remove bearing.
Note:
Bearing knocked out shall not be used any more, and should be replaced by new one.
Use special tools to disassemble bearing and oil seal.
16.4 Installation
Install according in reversed sequence of removal.
Note:
Use special tools to install bearing and oil seal in case they are damaged.
To Next Page
Loading...
