- 67 -
Remove the intermediate cap.
Connect the wires of ignition coils.
Ground connect the two ends (black/white)
of the primary coil to the car body to
create current divider.
Press the staring motor or step on the
actuating lever to measure the voltage of
the ignition coil at a time.
Minimum voltage：Above 95V.
*Note
Never touch the metal of test prod when
measuring the voltage in case of electric
shock.
2.3.2 Trigger
*Note
Install the spark plug in the cylinder head
and carry out the measuring when the
compression pressure is normal.
Remove the 4p and 2P joints of CDI group,
connect the peak-voltage magnetor
between the trigger with wiring 2p end
(blue / white end) and 4p end (black end).
Press the starting motor or step on the
actuating lever to measuring the peak
voltage of the trigger. CDI组：CDI group 黑：black 蓝：blue 白：white
Method of attachment: Blue/white end to
the positive pole and black end to the
negative pole.
Minimum voltage：Above 1.7V.
*Note
Never touch the metal of test prod when
measuring the voltage in case of electric
shock.
蓝/ 白
Ω
白/ 绿
To Next Page
Loading...
Need help?
General
