Process Monitoring
11.3 Creating Profile
Step 2: Entering designation and part number
The profile designation and
the part number of the blind
rivet are now entered one af-
ter the other.
The designation of the profile
should clearly identify the
blind riveting point; the des-
ignation of the blind rivet and
the thickness of the material
to be joined (FG 2.5) are
specified in the example.
The designations used can-
not be transferred to new
profiles.
Step 3: Recording process curves
The GAV device is now
ready to record process
curves.
The evaluation parameters
are adopted from the profile
last used.
To Next Page
Loading...
