GRAPHTEC LABELROBO LCX603 - Page 155

5-7
Chapter 5 Replacing Consumable Items
If the laminate material backing sheet is overly sagging, twist the laminate winder bobbin to
wind it up. Since there is a rotational direction in the laminate winder bobbin, refer to the below
illustration when winding.
PresstheFEEDkey,andalwaysmakesuretherearenowrnkleswhenfeedngthelabelmateralandthatthebackng
sheetswoundnthewnderbobbnwhenthelamnatemateralsfed.
When the below message is displayed, release the ribbon lever set-up.
'
'
'
'
W 0 4 : L o a d i n g c h e c k
R i b b o n l e v e r i s s e t .
C a n n o t f e e d .
Y E S : E N T E R