5-8
Chapter 5 Replacing Consumable Items
5.2 Replacing Label Materials (media)
This section explains replacing laminate materials.
•
When replacing ink ribbons or label materials, use a cleaning stick to clean the heads. If the heads are
not cleaned, stripes or white spots might develop. Always turn off the power before cleaning the heads.
• When the laminate materials have been replaced with a different type, it is necessary to change the
settings/adjustment. Refer to "5.5 Setting/Adjustment During Replacement" for details.
• When replacing label materials, it is necessary clear away any remaining label materials in the
feeding section of the main body. When clearing away label materials, remove dancer rollers 1 & 2
from the main body first.
• When replacing label materials in the middle of an operation, it is recommended that all remaining
data be output before replacing (refer to "4.5 OUTPUT ALL".)
• When removing label materials from the printer, make sure to cut the laminate materials first. If the
laminate materials are left as is, they may become entangled in the feed roller.
• Do not feed when the tape that stops the label material winding end is still attached. If the tape is
left attached when changing the label materials, it might become entangled in the feed roller and
cause damage.
•
The width range of label materials that can be set are selectable between 70 and 130 mm. Refer to the
below diagram for the relationship between the label and laminate material and the printing range.
• Label materials (media) Width: 40 mm - 100 mm (depending on utilized media)
• Label materials (media)-sending direction: 65 mm - 200 mm
Feeding direction
*Unit: mm
Label material width = W
Printing range (Cut width)
= W - 30 ≤ 100
15
10
Laminator material width = W - 20 ≤ 110
10
Material clip area
15
Material clip area
• Refer to "2.5 Setting Label Materials (media)" and "2.6 Loading Label Materials (media)" for details
on how to set label materials.
• Although there is an involution and revolute in the label materials, use the revolute in this model.
• When the label materials must be changed, the “ Confirm Combination!” screen is displayed. Refer
to "Confirm Combination! Screen in 2.3 Using the Control Panel" for details.
'
'
'
'
C o n f i r m C o m b i n a t i o n !
H 3 = S e m i - R H 2 = S e m i - R
H 1 = S e m i - R F N S m a t N 5 0
Y E S : E N T E R N O : E S C
To Next Page
Loading...