GRAPHTEC LABELROBO LCX603 - Page 157

5-9
Chapter 5 Replacing Consumable Items
Replacing Label Materials (media)
When replacing label materials that have run out, there are also cases when you have to replace the label material in
the middle of an operation.
When replacing in case the label material has finished
Clear away the remaining label materials in the main body and replace the label material.
When replacing the label material in the middle of an operation
Make sure to remove the media stocker, cut the label materials, and clear away remaining label materials in the main
body before replacing the label materials.
Replacing
Do not wind back the media in the main body. Winding back forcibly could result in a malfunction. Sever
the remaining media in the main body with scissors.
• Be careful of dropping the media stocker as it is heavy.
• When taking out the flange, take hold with both hands.
• The flange cannot be taken out when the media stocker is attached to the main body.
• Clear away the remaining label materials in the main body and replace the label material.
If the laminate materials are set, cut and remove them from the label materials.
$VU
• If the separator is set, remove dancer roller 2, open the separator, and then cut and remove from
the separator winding bobbin.
%BODFSSPMMFS
4UFQ
4UFQ
4FQBSBUPS
4UFQ
$VU